This kit contains all that you need, to make a fully working RapidBot 3D Printer. This kit comes standard with additional items such as: kapton tapes, heated bed for ABS & PLA, power supply, usb cable, few mtr PLA , Linear motion guide ,flange Bearings,flange nut etc to make sure it’s a complete kit.

• Overall size 38.2 x 38.75 x 36.93 cm
• Build size 22 x 22 x 16.5 cm

This complete RapidBot 3D Printer kit contains :

• Generation 6 Electronics - including opto's on correct cable lengths with molex connectors and high temp heat cables for connecting Heater and Thermistor
• All hardware cut bearings, bars, studding & bolts, nuts, washers, , Linear motion guide ,flange Bearings,flange nut etc
• All acralick cut sheets (Side plates, Bottom plate, Top plate, Middle plate, Y frog support, Y-frog, Extruder base, Extruder motor plate, Heated printbed and opto-flag) 
• M8 Threaded rods (330 mm)
• Chrome plated Smooth rods (330 mm)
• Printed plastic parts -  plastic set (Pulleys, Clamps, Holder, Extra fan support, etc) & Extruder plastics for J Hotend  
• Motor set of 4 - including correct cable lengths and Molex connectors (plug and play with Gen6 electronics)
• M4 Brass insert piece - for direct drive on motor shaft (5.1mm inner diameter)
•J Hot end partially pre-assembled, including Heater block, G550 Thermistor, Heat Resistor, Cooling fan, etc
• Silicone sealant (used for placing Thermistor and Resistor in Heater block)
• Kapton tape 15mm (Insulation of Thermistor legs)
• Kapton tape 40mm (To print on)
• Set of 4 Heater blocks, 4 x 1.0 Ohm (for Heated printbed)
• Cooling paste (To use between Printbed and Heater blocks)
• PTFE strain-relief
• X, Y and Z belts for RapidBot 3D Printer
• Power Supply 96W, Input: AC 100-240V, 50-60Hz, 1.3A, Output: DC 15V~20V, 3.5A
• USB and Power supply cables
• Plastic tie
• Extras such as Optos, Magnetic leveler, Forceps, Few mtr of PLA for first

If you're interested in buying our other mendel related products, kindly visit our website-

http://makemendel.com/
or mail us at
support@makemendel.com